For the Ø3mm dimension you are dimensioning from the ENDPOINT of the angled/vertical lines to the centerline. These last two dimensions sometimes give beginners trouble (especially placing angle dimension). Add the remaining diametrial dimension and then add the angle dimension by selecting the angled line, the centerline and then clicking where to place the dimension. (Tip: Remember that you can click and drag line endpoints.)ĥ. Trim the centerline (new command we haven't done). Sketch the right vertical line and angled line to the centerline to approximate size. Sketch the top vertical line and dimension the 10mm. Sketch the left vertical line from the origin and add the diametrial dimension. Sketch the horizontal line from the origin and change it to a Centerline.Ģ. Start a new mm part file and create this sketch on the XY Plane.įortunately - you get to use a "cheat sheet".ġ. Test 1 (I told you that you would be tested on this stuff).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |